Lionel 289E finally clean

The Lionel 289E is a heirloom item and so I waited a few years more than normal to remove the paint and get it repainted. The various paint layers where more difficult to remove than I previously had experienced. The top-layer was a hand-brushed thick layer of alkyd paint and underneath was the original gun-metal coating. I started with the conventional cooking pot method with old-fashioned near boiling soap-water. That removed most, but not all. Especially from the inside of the engine shell, hardly any paint was lost. People on internet-fora advised me not to sand-blast the item because of the fragile nature of die cast iron. So, I continued with carpet-glue-remover. This produced a thick gray gel of swollen paint that could be scraped off. Then I used the dremel and a brash brush attachment the remove the last paint residues. The cast iron shines and turns a bit dull in a few hours time. It behaves so different than tin-plate. Here is small picture of the shell ready for primer.